Date: Sat, 30 Jan 1999 21:47:19 -0800
From: Paul <rotaryeng@earthlink.net>
To: z <rotaryeng@earthlink.net>
Subject: Neil heat exchanger and strange low frequency vibration.
Jim Mosur wrote:
Paul.
Before I get into heat exchanger I have a question.
Today I flew my RV 6 with Neil K Ivo prop on it, I am running a 13B,
plugs up, with a Ross PSRU 2.17-1. I have been flying with a
Aymar-Demuth 68 x 74 wood 2 blade prop, for 37 hrs. I have been
experiencing a continuous pulse or throb at any constant RPM flying or
ground running, sounds like a twin with props out of sync. Running
Neils small dia. (60") 3 blade Ivo the throb has disappeared, we
checked my Aymar-Demuth for balance, pitch and run out, all were
perfect. I intend to fly tomorrow with more pitch in the Ivo as we had
it set a little fine, bags of revs. but not much speed. I had
orignally thought the throb was caused by having my conical engine
mounts cranked up too tight, but now, any thoughts?
I flew with the new oil heat exchanger that Neil and I have been
working on, it is slightly different than the one Neil showed in his
dwg. it has 672 sq. in. of cooling area . I had removed the
thermostate and balanced the flow to both rads. which are in the nasal
ducts. OAT 34F, coolant temp in engine 180F, coolant temp return to
heat exchanger 165F, oil temp 175F. The temps did not change although
I varied the Rpm from 5400-5900, the test flight was not long around
20-25 minutes. I guess with the prop in fine it really did not load
the engine up much but we will see how it is tomorrow with a coarse
pitch.
I'll keep y'al posted.
Jim Mosur
Sounds like you have some weird resonence problem.
Try adding a large weight to the engine as far out as
possible without exceeding the CG limits to see if it goes
away or changes.
Run it on the ground and stand along side the engine
and feel things like motor mount tubes and see if
something is vibrating excessively.
Look inside the bell housing and see if that Ross
clutch disk center is OK. Check run out on the input
shaft and output shaft of the Ross gear box.
It's a mystery all right.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org
______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com