Jeff Spitzer wrote:
At 07:27 PM 1/29/99 -0800, you wrote:
Gerry Hess wrote:
Jeff Spitzer wrote:
I think this thing is inside out. Oil has much worse heat transfer
characteristics than water and needs the extra area. I understand that
this unit has double area for water than it does for oil.
Jeff Spitzer
Yes, those were my first thoughts, too. This is electronic heat sink
stock, and I can flip it either way you like. But.. My understanding of
thermal dynamics ( very limited, I will leave it to the pencil pilots!) is
that heat energy excites electron movement in atoms, and the desired state
of any material is one of the least movement (or absolute zero). So in
short
heat flows toward cold, to attempt to achieve this state. The higher the
heat, (like pressure?) the faster the transfer. The cooler material is the
water inside the heat exchanger. My thoughts were that the temp difference
would balance out against the poorer transfer rate of oil. The labyrinth of
the internal flow should break up any boundry layer by creating turbulance
in the water flow.
I can probably be proved wrong quickly, but lets hear some reasons, and
discussion before I finish welding this thing up. It seems to be a better
system then the old coil in the oil trick, and I remember back in Contact
magazine, when Tracy Crook built his first cave-man version of his engine(3
Mikuni's) the coil in the oil upped the thermal efficiency of his radiator
as well and caused the engine water temp to run cooler.
Gerry
I hear what you are saying and it has no relation to actual engineering.
The aluminum temp will be a function of the heat flow in and out. The heat
flow in and out will be a function of the surface areas and the heat
transfer coefficients (and the resulting temperature differences which
result) The oil has significantly poorer heat transfer coefficient and
therefore needs more area. Trust me, your logic is flawed.
Jeff Spitzer
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org