Subject: Fwd: Building your own E-shaft ignition trigger.
From: "Perry Mick" <>
Date: 2/2/1999, 5:32 PM
To: perrym@teleport.com




Date: Sat, 30 Jan 1999 16:48:54 -0800
From: Paul <rotaryeng@earthlink.net>
To: z <rotaryeng@earthlink.net>
Subject: Building your own E-shaft ignition trigger.

Tracy Crook wrote:

Subject: Building your own E-shaft ignition trigger.

snip......

This can be used to replace the distributor with Tracy's
engine system computer.

Paul Lamar


Circuit will work fine but the Mazda sensor has a bit more to it.  
There is
a second sensor that triggers every 30 degrees of shaft rotation.  A 
second
sensor (and more holes) would do the job.   100 ma sounds high for the 
LED
current.  Did you mean 10 MA?

Tracy Crook   rws@altavista.net


Nope! 24 mw at 1.2 volts or so as I recall.  Those are 100 ma LED's. 
High power infrared LED's.

Some are only 50 ma and put out the same amount of light but they are
not listed in Digi Key. More money too. 

BTW I have come up with a way to do this with out drilling large holes
in the fly wheel. More later.

What kind of pulse do you need Tracy?  I will add a little
pulse conditioning at the computer input. 
Voltage? Width? Polarity?

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org


______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com