Date: Sun, 31 Jan 1999 01:26:35 -0800
From: Paul <rotaryeng@earthlink.net>
To: z <rotaryeng@earthlink.net>
Subject: Building your own E-shaft ignition trigger.
Tracy Crook wrote:
The edge timing is all that matters. There is a low pass filter in
the
controller to filter out noise. A 5 volt amplitude referenced to
ground
will work fine. No need for the capacitor between sensor and
controller.
Tracy Crook rws@altavista.net
Unfortunately the saturation voltages on the photo detectors
are too far above ground to be reliable as CMOS or TTL input.
I will add a CMOS circuit to give you a zero to five volt pulse.
Also Digi Key has a new photo detector with built in signal
conditioning.
It has 50 ma current source and sink. It might work if you want to
try one of those. Look on page 553 bottom right hand corner.
Unfortunately the wave length is 935 instead of 880 but that might
be close enough. The reception angle is wider at 25 degrees as well
which implies less sensitivity. The upside is they switch
in 70 nano seconds. You will have to add a zener to prevent
spike damage as they only handle 16 volts peak.
QSE156QT-ND is push pull and QSE157QT-ND is open collector.
A buck fifty eight cents in either case.
I will upload the signal conditioner in case these things don't work
well.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org
______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com