Subject: P51 duct mold section listing half size.
From: Paul
Date: 2/2/1999, 5:25 PM
To: z

Jeff Spitzer wrote:

At 10:52 PM 1/29/99 -0800, you wrote:

I don't think the fuselage structure is an insurmountable problem.
Perhaps in the case of a Lancair IV where you have the gear.
In a case like that you might want to use Spitfire type rads.
IMHO the composite fueslages are easily modified around this duct.
It is not a high stress area of the fuselage.
I'll have to ask David Lednicer where the air from the oil cooler goes.
I would assume under the water rad.

I hate to ask him for the outside. He has been so helpful so far.
Why don't you give it a stab. David Lednicer <dave@amiwest.com>

Paul Lamar

Careful Paul!  Don't advise people to modify structures unless you know of
what you speak.  The bottom center IS a structurally significant area in
most structures.

Jeff Spitzer

Thats true. I would not cut any stiffeners, longerons or stringers. 
The thin skin is in compression in that area for the most part  and as
such 
it has very little compressive strength to begin with. The duct would
probably 
add column strength and reduce potential skin buckling as long as it was
well
tied in with the rest of the structure.

Paul
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org