Subject: Cost of a 240 HP peripheral port engine.
From: Paul
Date: 2/4/1999, 11:47 PM
To: z

Chuck_Harbert@arkwright.com wrote:

Paul, I've been reading the correspondence on peripheral ports with
interest. I talked to Skip Gorman who raced this type of engine and he said
that this was a full race type application, if you're planning on making
250hp. It barely runs under 6,000 rpm, makes a tremendous amount of noise,
and gulps fuel like there's no tomorrow. It also takes very tuned intake
and exhaust systems to get this kind of HP. The torque also is not much
under 6K. I thought Everitt was using a PP engine and that he was looking
at about 200 hp using butterfly valves to make it idle. He spent a bunch of
time developing a compatible airplane engine.

All this doesn't sound to me like a good (reliable, econmical, reasonably
priced) airplane engine. If you want 250 hp out  of a 13B, why don't you
just turbo it? Then it's good for altitude speed, as well. Couldn't stand
to keep quiet.

Paul <rotaryeng@earthlink.net> on 02/01/99 09:50:56 AM


I think that is an exaggeration. The engine does indeed generate 
quite a lot of HP below 6000 RPM. An aircraft engine is not like a
car engine. There is no real need to run it much below 4000 RPM. 
The noise should be roughly the same as the exhaust port is 
unchanged. The noise should be relative to the amount of HP it is 
generating. 

The guys don't seem to be getting the HP with the 
side ports. People with 180 HP and 200 HP aircraft engines in RV's
and Lancairs are going much faster. Everett's peripheral port
engine was the only rotary that could run with them. 

The BSFC in fact is better with
the peripheral port as the VE is higher. The Le Mans peripheral port 
engine proved that.

The idle problem can be solved by copying Everett's idea
of putting butterfly valves in the intake near the housing.
No big deal there. You need at least one butterfly valve 
somewhere. So now you have two. No big deal.  

An Inconel turbo, Inconel exhaust manifold and intercooler  would 
be much more expensive than a home made peripheral port engine.

A turbo system  would also weigh more and require knock sensors to 
prevent potential problems with broken apex seals. Not to mention
the ducting required for the intercooler.

I think peripheral intake ports are an easy sure fire way of 
getting 200 HP at 6000 RPM. No trick side porting. You save the 
cost of having someone street port your end housings. 
Just fill them up with epoxy.  The intake manifold is simple 
and stright forward. Just make it 24 inches long. 
The power to weight ratio would probably be better than
any aircraft engine.

As Archie  says, once you set up the mill it is no big deal 
to knock out half dozen or a dozen..

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org