Subject: Fwd: Building your own E-shaft ignition trigger.
From: "Perry Mick" <>
Date: 2/4/1999, 1:45 AM
To: perrym@teleport.com




Date: Sat, 30 Jan 1999 12:00:21 -0800
From: Paul <rotaryeng@earthlink.net>
To: z <rotaryeng@earthlink.net>
Subject: Building your own E-shaft ignition trigger.

This circuit will cost you less than ten bucks.

I have used it for years with excellent results.
The rise and fall time of the photo detector
is on the order of 15 usec. Keep the load
resistor R2 small to achieve this rise time.

It is highly accurate ignition timing  because of 
the large diameter and rigidity of the flywheel.

The five volt regulator can be had almost anywhere
including Radio Shack. The LED current should
be up around 100 ma. Adjust with R1.

Buy a couple of extra parts until you test it
throughly. A build or design error can blow a part
faster than you can say nanosecond. 

The idea  with these LED's and photo detectors is
you want a narrow beam width. That means a fat lens
on a metal case.

Digi Key 1-800-344-4539 Jan Mar 1999

Page 552 fig 10  PDI E805-ND TO 46, plastic lens, 5 degree beam width
high power infrared emitter $3.  880 wave length

Page 552 fig 7  30 v 8 ma 14/16 usec 12 degee reception angle
880 wave length, $1.80.  Part # l14 P1QT-NT photo detector
Probably a TO 46 package.

This can be used to replace the distributor with Tracy's
engine system computer.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org



______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com