Subject: Long pipes on turbo charger intallations.
From: Paul
Date: 2/4/1999, 6:49 PM
To: z

Tracy Crook wrote:

Paul Lamar wrote:

The Feb issue of Wings mag had a great article on the P51
and P47.

This diagram of the P47 turbo charger installation just
shows to go you there is not that much disadvantage to
remote mounting a turbo charger. The short exhaust pipe
idea came from automobiles where throttle response was the
be all and end all.

The P47's top speed was over 400 MPH at 26,000 feet.

Paul Lamar


This is neat stuff Paul, I had no idea the P47 was plumbed that way.  This
is the approach I plan to take with the turbo charged 13B powered RV-8 I am
planning.  (I've decided against the 20B)   The distance will be
considerably less than on the P47 but still far enough away for the flames
to die down before the turbo.   The EGT is my only reservation concerning
turbo operation of the rotary.

Yes, I have heard the stories about the exhaust being hotter the further out
you go on a rotary but I think these are racing stories with engines running
very rich mixtures.   I haven't proven it yet with instrumentation but the
header pipes on my RV-4 show evidence that  the exhaust cools off after
about 18 inches at the lean mixtures I typically run at.

 BTW,  my 321 stainless exhaust system (all .035 wall tubing) is still
working after 800+ hours.   Everett looked at it three and a half years ago
at Oshkosh and said "It will probably  last only a few hours" :-)

Tracy Crook   rws@altavista.net


And I thought nobody noticed snif :-)
 
Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org