Subject: Fwd: 4 Bolt Exhaust Flange
From: "Perry Mick" <>
Date: 2/6/1999, 6:31 PM
To: perrym@teleport.com




Date: Tue, 02 Feb 1999 11:18:41 -0800
From: Paul <rotaryeng@earthlink.net>
To: z <rotaryeng@earthlink.net>
Subject: 4 Bolt Exhaust Flange

Lonnie Wood wrote:

Hi Paul,

I have some questions on the Hatch 4 bolt exhaust Flanges.
1. Can this be done whith the engine assembled?
2. What stud diameter and length is used?
3. How deep can you drill whith out punching through to the
rotor chamber or possibly a water chamber?
4. How thick is the flange? From the picture is looks about 3/8".

This does look like a much better way to hold the exhaust on
and much less potential for leaks.

Lonnie
rwood@iceinternet.com

Good question Lonnie. I would not do it with the engine
assembled for all the reasons you mentioned. The stud I would
guess is about 5/16 dia.

I can give you the dimensions on a late rotor housing
but I am not sure they would be the same for yours.
 
Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org


______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com