Bulent Aliev wrote:
HI Paul,
Tracy's style motor mount - 1/4" alum. plate sandwiched between the oil
pan and motor was used on the CZ MK IV : photo is posted on your web
site.
OK that must be the Ed Heishman picture under the PSRU catagory.
The thrust line I think is about 2" below the top longerons which
does not live much room on top. I like the Questair motor mount better,
or combination of both.
I will adjust the drawing.
One problem: I have no clear understanding about
the tube going inside the alum. sleeve in the oil pan. Where it is
attached to the engine?
Yes I left out the little bolt that goes through the aluminum tube and
the
two inch diameter 0.050 wall 4130 steel tube. Could be as little as 1/4
inch as there is hardly any lateral load on it. Use one on each side
if only one scares you :-) Actually the best place for it is inside
the pan on center line as the stress in the steel tube is a minimum
there. Any hole in the steel tube constitutes a stress concentration
of course so it is a wise idea to put the holes away from the max stress
areas which are just outside the pan.
The aluminum tube of course is welded in the aluminum pan.
The pan should be made from at least 0.090 and possibly 0.125 thick
aluminum sheet 5052 or 6061 weldable alloys.
Another thing: The exhaust in the Cozy's usually comes out closer to the
prop hub so does not disturb the air flow for the prop.
Well that's interesting. My take on that is the rotary could over
heat the prop.
Klause runs his O-200 exhaust out the sides about where I show it.
Perhaps a little more inboard.
The prop on a pusher gets a lot of abuse anyway being in
the wake of the fuselage and wing. I don't really think the exhaust
being out that far out will have much effect. I could be wrong.
Makes a very simple tuned exhaust system however. The prop gets
more of a chance to cool off during each revolution.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org