If your engine still does not idle to your satisfaction
use just the end housing ports for idle and the peripheral ports
for top end power. Four butterfly valves instead of just
two. Don't pour epoxy in there just yet.
The same four injectors. Stage the throttle
linkage so the peripheral ports stay closed up untill
half throttle or so and the peripheral port injectors
stay off. You should get even more power on the top end.
Another possibility that might work is pump fresh
air into the peripheral port between butterfly
and rotor during idle. Electric centrifugal blower?
Supercharge the idle :-)
BTW if you don't have access to a machine shop take a
course in machine shop at a local juniour college.
Out here in CA the cost is about $50 dollars a semester.
I took a course in numerical machine tool programming
that I found fascinating. Got to play with $50,000
NC mills and such.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org