Anderson Ed wrote:
Hi Paul and all,
Wanted to report on status of my 13B, oil cooling problems, etc.
As I have reported, my oil temp problem has improved considerably over
the earliest flights. I initially thought the 5" duct modification was
the total solution, and it was on a 15F day, however subsequent flight
on a 50F OAT day indicated it was still marginal at high power
settings.
I decided to place two vortex generators near the NACA duct to see, as
some have reported, whether it would improved airflow into the duct.
Well, I don't have the final answer on that, but I did discovered
something else which did affect the oil temp.
Don't ask me why I did not notice this before, but on this flight I
happend to notice that at 4800 rpm my EGT was 1500F, but at 5200 rpm it
was 1450F and at 5500 rpm it was 1250F. Anyone notice anything strange
about that progression? As much as I don't like to do it, I opened up
the laptop and started adjusting the high rpm injector timing (above an
airport with a long runway - just in case. All the more reason to go
with a adjustment readout like Tracy Crook has on his EFI).
As I reduced the injector timing for the over 5000 rpm bands, the EGT
started to increase and the power/performance picked up as well. I
reduced the injector timing by an average of 20-25%. Apparently my
mixture was so rich at high RPM setting that there was insufficient
oxygen in the exhaust gas to combust it all and it was cooling down the
exhaust and therefore the lower EGT readings for high rpms. Where
previously my ROC at 6000 MSL was around 1000 fpm, after the adjustment
it was up to 1350 fpm. My top airspeed increased by 6 mph to 180 TAS,
so the adjustment did effect performance.
Now, what was an additional benefit, although I don't understand why, is
the oil temperature dropped approx 10F over what it had been at the
higher rpms. Would anybody hazard a guess as to why the oil temp would
drop with less fuel flow??
So once I get my intake manifold reworked and pick up a few more horses,
this machine will really start to perform. Had to take off a fuel tank
and replace a gasket to stop a seeping leak around an access plate -
which was a pain, but the time could have been better spent on a new
intake manifold.
Ed Anderson
Have you measured the aerodynamic pressure on both sides of that oil
cooler?
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org