Most airplanes have a long push pull rod for elevator control.
Unfortunately this is right where you want to put a P51 style
cooling duct. Consider moving this control over to one side
or the other of the aft fuselage to make room for an efficient
P51 style cooling duct. This probaly could be done with
a short torque tube just ahead of the duct or just behind
the seats. Use a 1 1/2 inch diameter or larger thin wall
4130 torque tube and large diameter light weight "helicoptor"
type ball bearings to maintain good control rigidity
and feel.
Here is a sketch of a suggested modification to the typical
elevator control. If some one has a drawing of the controls
for a Lancair, Glasair, Glastar, RV or any other airplane
please scan it in or zerox a copy and send it to me.
I will then draw up better details.
This is a very important detail in obtaining a satisfactory
installation of a liquid cooled aircraft engine.
I have the plans for a BD-4.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org