Subject: Chemically machining cast iron end housings
From: Paul
Date: 2/11/1999, 3:45 PM
To: z

Tracy Crook wrote:


Here is an idea I have been thinking about for awhile.
Bolt all three cast iron housings together with sheet
silcon to act as gaskets and circulate acid through
the coolant passages. It should cut the weight and
increase the coolant flow capacity in one fel swoop.

You might have to build a rig that jiggles the set around to
promote equal effect.

Of course you use plastic pumps and plumbing.

Paul Lamar

The thinnest section in the end / side housings are the wall between water
jacket O-rings and the water passages.  Failure of this wall is one of the
most frequent failure modes of the 13B.  If you etch this area, things will
go bad in a hurry.  I think it would be a must to protect this area if you
contemplate doing anything like this.

Tracy Crook   rws@altavista.net

Good tip Tracy thanks. I have a couple of housings I can play with.


Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org