Subject: Measureing the parameters on high continuous HP in a car.
From: Paul
Date: 2/14/1999, 10:56 PM
To: z

David Munday wrote:


Loading up the car, I understand.  What I was asking is how you would
instrument the thing to reveal the inadequacy of the stock turbo once
you get the Hp up to 200 Hp or so and keep it there for a while.
Where would you take the temps and pressures?

Cooling will start out stock, then be augmented with evaporative
cooling while in the car, on the assumption that I can always add more
radiator when it goes in the plane to get the heat out of the coolant.
The real question is probably how much heat you can get out of the
engine and into the coolant.

--
David Munday  -  mundayde@muohio.noise.edu
My email address is not noisy.
Webpage: http://www.nku.edu/~munday
PP-ASEL  -  Tandem Flybaby Builder  -  EAA-284 (Waynesville, OH)
"Adopt, Adapt, and Improve" -- Motto of the Round Table

As Paul Yaw just pointed out monitor the turbine RPM and
keep checking for cracks. It is a question of durabilty.

Needless to say the turbo system  was never engineered to
generate that amount of HP on a continuous basis. The engine
revs up and the transmission shifts everything is over
in less than ten seconds on an acceleration run. 

Nobody drives the car anywhere near its top speed for very long. 
Even in the wilds of West Texas I was never able to sustain much 
over 100 MPH for more than about 15 to twenty minutes. I simply got
to the next town. And that is still not max HP. I was not driving
a turbo rotary. Merely a V6 Olds minivan.

It is quite remarkable that the basic rotary engine is up to it.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org