Subject: Measureing the parameters on high continuous HP in a car.
From: Paul
Date: 2/15/1999, 10:28 AM
To: z

Jeff Spitzer wrote:

David Munday wrote:

Well I just bought a 13B Turbo motor which came wrapped in an '87 RX7
test mule.  I plan to put temp gages all over as well as pressure
gages and anything else I can think of.   Where would you think gaging
is most important?

One of my goals is to investigate your position that the stock turbo
is unsuitable for high sustained power settings.  How would I most
quickly prove you right (or wrong as the case may turn out?)  It'll
likely be a few weeks before I get the thing on the road.  I want to
go through the whole car while I still have Dr. Frankenstein's Swedish
Meatball as a daily driver.  I may not get all the instrumentation in
at first either, though I want to start thinking about how to fully
instrument it.

--
David Munday  -  mundayde@muohio.noise.edu
My email address is not noisy.
Webpage: http://www.nku.edu/~munday
PP-ASEL  -  Tandem Flybaby Builder  -  EAA-284 (Waynesville, OH)
"Adopt, Adapt, and Improve" -- Motto of the Round Table

I am very interested in the results of this turbo torture test.  Let me
know if I can help.  One thing I would suggest would be to add an EGT
sensor right at the turbine inlet - maybe even right in the beginning of
the turbo inlet scroll.  Everyone will want to know what the actual TIT was
for the sustained torture test.  I read on your sig line that you are in
Ohio.  So I guess there's no cahnce of getting some altittude for the tests
huh?  The turbo spins faster at altitude for the same MAP.  If you could
run the thing up pike's peak, pulling Paul's trailer and getting 30+ inches
of MAP that would be a true torture test.

Jeff Spitzer

The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org