Subject: Chart inlet & outlet area verses ambient temperature.
From: Paul
Date: 2/18/1999, 9:41 AM
To: z

Neil A. Kruiswyk wrote:

Paul,


[Blanton's rad installation in his Ford V6 powered Cessna]

    He was definitely doing something wrong.  He had far too tight a bend in
and out of the rads and virtually no plenum area in front of or behind the
cores.  Alan's RV-3 had a massive plenum area and as I recall, excellent
sealing everywhere.

    Reducing cooling drag to zero is easy.  Eliminate the radiator.
Unfortunately you also reduce cooling to zero (tongue in cheek).  I'm
stating the obvious here but the trick for us experimenters is to get
maximum cooling at minimum drag and still get it to fit in the airframe.  It
also has to work through all flight characteristics.  And lets not forget
aesthetics.  It's a lot of give-and-take.

    Fred ran some numbers on my proposed scoop design over different flight
conditions.  Here is a chart that provides food for thought.  If you charted
drag it would probably follow the lines proportionally.  Given this chart
information, if I build the scoop with hot climb in mind, I should be able
to cover all other flight conditions.  An exit flap will help lower drag for
certain conditions.

Neil


 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

in-out-area-v-temp.jpg