Subject: Cooling a Ford V6 STO
From: Paul
Date: 2/18/1999, 11:06 PM
To: z

kustom@oz.sunflower.org wrote:

PL wrote:
Don't let all this talk discourge you. We are basicly trying
to minimise the drag so we can go 250 MPH. If you are flying
low and slow with a rag wing don't worry about it. Plenty
of room in the aft fuselage for a big rad just like the guys
with the V6 STOL. I would put the intakes on the sides however
as far forward and as high as I could... to take advantage
of the high pressure under the wing. No problems letting the air
come out under the stab.

BTW Tracy has a quick and dirty solution. He sprays cold water on
the rad when he is balked at taking off. Get his book and decide.

"Tracy 2 rws@altavista.net" <rws@altavista.net

PL


Actually I have been in love with this engine myself for a long time,
but have been getting a little discouraged about cooling since reading
the emails lately. I am considering mounting one of these rotarys on my
BD4 so I'm trying to soak up all I can about cooling with that aircraft
in mind, sure seems to be the toughest problem talked about.
 Rod Sebby

A big rad will fit in the back of a BD4 too Rod. Don't worry.
You don't even need a doubler around the holes under the stab :-)
I got the plans right here. Just don't cut those G7 diagonals 
in there.

In fact with an almuminum high wing you won't even need an
insulated  duct aft of the rad. 

A non-insulated duct might lower the drag a wee bit however.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org