Jeff Spitzer wrote:
At 07:48 AM 2/19/99 -0800, you wrote:
OK what happens when we add heat? hoefig17.jpg
On the lower left of the chart in the part labeled
propulsion we are in the ram jet mode Jeff mentioned.
As the flow rate increases we exit the ram jet mode
and the drag is rapidly increasing.
IMHO this would suggest to me we don't want external diffusion
if we expect to get P51 type results. I could be wrong.
Why? Because external diffusion does not work well with
low flow ratios. Comments?
PL
I follow your logic, but don't agree with it. My answer is that you do the
best you can with want you have. For all you tractor guys, if you can
stuff the coolers in the engine compartment then you will use external
diffusion on the front of the cowl. There will be no particular penalty
here because the air already has to accelerate around the outside of the
cowl and the increase in cowl drag due to external diffusion will be
negligible. I think a fine cooling system can be done this way. (BTW, the
previous discussion about "prop turbulence" is hogwash in this case because
the "turbulence" won't hurt an external diffuser) In a P51 type
installation external diffusion is going to cause additional airframe drag
two ways. 1) Accelerated flow around the scoop. 2) Interference drag of
this accelerated flow passing through the splitter area and near the fuse.
In this case you need to use the internal volume that you have to install
an internal diffuser. CAUTION: Diffusers HATE to turn corners. Diffusing
around a corner is very tricky (a la P51).
Bottom line on external vs. internal: You just have to do the best with
what you have and understand the tradeoffs of each.
Jeff Spitzer
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org