Bill Freeman wrote:
Paul,
Several items:
1) I need to know what the variable stand for on the hoefig17.
That's a lot. I figured you would have Hoerner's F.D.D..
w is the average flow velocity in the duct.
V is the airspeed of the airplane.
The funny looking squiggly line is loss coeficient.
A complicated function in and of itself.
C sub Da is a drag coefficient probably based on
the frontal area of the duct.
2) What exactly do you mean by " low flow ratios"? If you
mean the "choked" case from Jeffs diffuser sketch #2, (bottom
of page) then, sure - but so don't DO that! Design the system
to capture an appropriate quantity of air for your cooling needs.
" low flow ratios"
That is when the average air velocity in the duct is much less than
the airspeed. An infinetly thin wall cylinder would have a flow
ratio of one. IMHO The problem comes when you have a thick high
pressure loss radiator. That's when the flow coefficients get low.
Ironically that's when you can build a net thrust internal diffuser
cooling system like the P51. I could be wrong about all this.
None of it is very clear. For one thing we have no data on the
radiators we are using. PL
3) On your rad testing rig - haven't figured out exactly what
you are doing yet (my lack of effort, not your fault) but did
want to suggest that duct tape is a great release if you want
to dig out the styrofoam form, but I just lay up over the
foam, disolve out the STYROFOAM (won't work with
urethane!) with gasoline after and do a bit of sanding
on the inside of the duct if you want it fairly smooth.
Duct tape will give a good release and is super easy to
apply. Appropriate to use duct tape to make a fiberglass duct, no?
:-)
I made some special wierd ducts for the LE heating system
this way. If you want to attach aeroduct hose (bellows type)
to this duct, screw a piece of .049 or so wall alum tube about
2" long on the end of the styrofoam form, rough up the
end and lap about 1" onto it with the glass/epoxy. Works
like a charm and you can easily make ductwork that is as
complex as what you have under the dash of you car. :-0
A key point that Jeff made in his sketches that I want to
point out so we don't gloss over it is - With a well done
external diffuser you can recover essentially FULL pitot
pressure. I can't be sure I'm reading his note properly, but
I think he wrote that the upper limit for internal diffusion
is about 20% recovery (could be 80%, tho, can't tell). If
this is correct, then the ext diffusion looks a LOT more
efficient.
This makes me think of the Linear Aerospike rocket motor
which uses an external nozzel (the opposite of a diffuser)
and is much more efficient than a conventional hard nozzle
(internal expansion) at widely varying external
pressures (like sea level to hard vacuum). I suspect that
tricking the air (propulsive gasses) into "doing the right
thing" is inherently variable in ways that will help efficiency
over a wider range than either a hard (fixed) diffuser or
fixed nozzle.
Bill
PS If you have not seen the linear aerospike rocket motor,
and have any interest in fluid dynamics, aerodynamics and
nozzle design or just NEAT STUFF - check out the web site
that Lockheed has on this.
http://www.boeing.com/space/rdyne/x33/aerospik/basics/basics.htm
This is extremely neat - looks so bizarre, yet is more efficient
over the whole range of operating conditions.
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org