Jeff Spitzer wrote:
At 10:48 PM 2/22/99 -0800, you wrote:
Paul Yaw wrote:
The stock Mazda oil coolers have a series of wavy wires running through
the tubes. It has been explained to me that they create some turbulence
so that a greater amount of the oil makes direct contact with the
cooling surface. I cannot vouch for this myself, because I simply do
not know enough about cooling, but it does sound reasonable. Does
anyone out there have any input?
PY
Oil is a very viscous fluid and has poor thermal conductivity to boot. If
you don't "stir" the oil as it passes through the tubes then the outer
"layer" will get cooled but not the center core. Turbulence tubes or fins
of some type are required for a proper oil (or air) cooler. They are often
not found on cheap water coolers (on the water side) because water has
vastly superior thermal conductivity and vastly less viscosity relative to
it's thermal mass (than oil or air)
Jeff Spitzer
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org