Subject: Tube type oil coolers.
From: Paul
Date: 2/23/1999, 10:57 AM
To: z

Jeff Spitzer wrote:

At 07:12 AM 2/23/99 -0800, you wrote:
Wschertz@aol.com wrote:

The problems with the tube-in-the oil-pan method that Tracy used, is
that the
oil is essentially quiescent, moving very slowly past the heat-exchange
surface, therefore the resistance to heat transfer will be greater.  The
fact
that it works so well indicates that you don't have to get a lot of heat
out
of the oil to do some good.

I disagree on this point Bill. There are about 40 gallons of oil moving
through
the pan from top to bottom per minute. The mixing might not be the
greatest
but never the less there is some flow through there. PL


No way!  40 GPM?!!!  I've never seen an engine this size do 40 GPM of oil.
I doubt the water pump even does 40 GPM.  Where did this number come from?
I'd believe 10 GPM as a high limit.

Jeff Spitzer

You are right. I was thinking of the water pump. The oil pump is 4.2
to 5.3 gallons per minute in the early 12A. I don't have the numbers 
for the 13B's. I looked it up in Bill Carrols book.

Thanks for correcting me on that.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org