Subject: Metering pump and oil cooking.
From: Paul
Date: 2/24/1999, 5:59 PM
To: z

Tracy Crook wrote:

Peter Cowan/Lexi Cameron wrote:

Would you mind going into more detail on your oil cooking experiment?  40
years ago the local gas dispenser commented that he believed 2cycle oil
was
just a marketing gimmick. After all, why should it be good oil when it
exists in the engine for a short time to be burned anyway? I've always
believed this too and rarely have used other than motor oil in my
outboards,chain saws etc. What did you find out??

Tracy Crook wrote:

Do Not listen to that local pump jockey.  I have spoken to several petroleum
industry engineers and they all agreed that the base stock used for
distilling two and four stroke oil is substantially different.  4 stroke
uses a parafinic (sp?) base and  2 stroke comes from napthenic (again sp?)
base stock.  The big difference is the residue left after they are burned.
Parafinic base leaves a hard deposit which will cause ring (or seal)
sticking. It makes a huge difference.

An exception is aircraft 4 stroke oil which is blended to burn more cleanly.
Those clumsy Lycoming & Continentals consume significantly more oil than
auto engines.  Two stroke oil is still the best choice for rotaries (in the
fuel, not the oilpan).

Tracy Crook   rws@altavista.net


 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org