Paul Yaw wrote:
Paul wrote:
Not much more than I already mentioned. Two cycle oil is the best all
things considered. Turbine oil is risky as it may have an effect on seals
used in the engine.
Here is a jpg of the apex seal temp. apextemp.jpg
You can see how important it is to cool these seals.
You need an oil that will take high temps.
Paul Lamar
Motor oil does not burn cleanly, and has a detrimental effect on the
detonation resistance of the fuel. When I disassemble an engine, I can
tell just by the amount of carbon buildup if an engine has used the
metering pump, or was run on a two stroke premix. Engine oil will leave
a TON of crud behind. In many cases, I have seen engines with no
compression, only to find during disassembly that an apex seal was stuck
in the rotor tip because of carbon buildup. In many cases a high
mileage rotary will start to develop detonation problems because the
carbon buildup retains heat, and ignites the mixture before the flame
front can. Increasing the output of the metering pump only makes things
worse.
Paul Yaw
So, Paul, I guess you recommend two cycle pre-mix. Is that right?
Sounds like it.
PL
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org