Subject: Splitter location for oil cooler
From: Paul
Date: 2/24/1999, 6:06 PM
To: z

Tracy Crook wrote:


Anderson Ed wrote:

Thanks for the additional info, Tracy.

I was particularly interested in your comments about the significance of
the shape of your airflow splitter and its effect on airflow.  The
opening to my oil cooler plenum is 5" in dia and I put a divider in the
mouth( about 1/3 of upper area) to force about 1/3 of the airflow to the
upper part of the oil cooler. The divider is an approx 1/8" thick layer
of fiberglass that curves from the mouth of plenum, against the plenum
sides to approx 2/3 of the way up the oil cooler.  Did this because my
opening to plenum is near bottom of oil cooler and I figured that a lot
of the air was just shooting throught the bottom rather than flowing
thru the top of the oil cooler.
I could not detect any noticable change.  However, perhaps adding a more
rounded airfoil type shape to the front edge of the divider may help.
That's the frustrating thing about messing with airflow, you don't know
how close (changing the shape) or how far your are from success.
Instrumentation, as Paul keeps advocating is apparently the only way.
Sigh!

Are you getting 5500 rpm with your Performance 68x71 Prop?? I am still
only getting 5000 rpm with my 68x72 at static and am still not getting
over 6000 in level flight.

Ed Anderson

The truth about this cooling system stuff is that there is no way anyone can
make a meaningful suggestion about your system without having a full &
complete understanding of what you have.  There are many variables and
details which can make a perfectly valid suggestion totally wrong in the
context of your situation.    For instance,  the airfoil shaped airflow
splitter in my right side inlet is the right answer in that exact location.
It was the wrong answer for the poor distribution of airflow across the oil
cooler core (I had this problem too).

The best answer I came up with there was to place some very diffuse material
over the area that was getting more than it's share of air. (I used a small
piece of ridge vent filter from the local builders supply)  This broke up
the flow and equalized the airflow through the cooler.   Note that this will
only work in the area of the system that is low velocity / high pressure.
It would be a total disaster if placed where the splitter is (high velocity
/ low pressure).    Again, this may or may not be the right answer for your
situation.  Crude drawings and verbal descriptions do not give the
information needed.  OTOH,  someone with the right understanding might be
able to look at your system and give you the answer after a brief glance.

Tracy Crook   rws@altavista.net

That's a pretty good idea Tracy. Now if I can get the guys to do 
a velocity survey one could taylor the flow through the rad so
it was more or less even. That might maxmimise the heat transfer
to the coolant. 

Thanks for sharing that. I will put that
in my bag of tricks. Good thinking.

PL

The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org