Subject: Boundry layer trippers for NACA ducts.
From: Paul
Date: 2/25/1999, 9:52 AM
To: z

Anderson Ed wrote:

Like the idea about adjustable vortex fence around the NACA duct, will
give it a try.

Thanks

Ed

Don't bother Ed. After seeing your sketch I don't think it will
help much. Focus on strightening that duct.

BTW you show a side air outlet is that sealed with the side of
the cowl and the louvers?

Is the down spout dumping into the cowl or out the bottom?

Another question. Is your PSRU 14.5 inches from engine to prop
flange?

>From looking at this picture it looks like you need to move
the rad plumbing to get room for a strighter oil cooler duct.
I would run the motor mount tubes through the oil cooler
duct if necessary. You could streamline them with foam and
glass if you are worried about the drag they might have.

Are those evap cores? What are the dimensions of those cores?

Are your cores in there at more of an angle than Tracy's?

Looks like you have considerable internal diffusion going on
in the water rad or evap core  system.


Paul Lamar      EA-underneath.jpg
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

EA-underneath.jpg