Subject: Makeing your own alloy end & center housings.
From: Paul
Date: 2/25/1999, 1:38 AM
To: z

Wrathall Mark wrote:

The Powersport rotary appears to have aluminum housings.

What sort of weight saving is this worth? How complicated would it be to
cast the end and center housings for a peripheral ported rotary?. The
casting would only require accurate cores for the water jacket (and oil
passages - or could this be simply drilled), as the rest would have to
be milled and bored anyway. Has anyone every tried an assembled housing?
Mill the water jacket and oil galleries into a slab of alunimium, then
bolt a closeout plate on the side, finally bore and mill the two seal
surfaces?

An early prototype did. The later ones were all cast iron.

Roughly 15-20 pounds apeice. The stock end and center housings
run around 35 pounds each.

The rear and center aluminum housings can be obtained 
from Racing Beat.

The gif is my suggestion for makeing your own.

I have some picts of cutaway end housings if you would like
to see what the inside looks like. You will need to copy
the passages as the water flow direction is critical.
I would suggest getting some late model housings and mill
them down to make exact copies.
 
Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

endhous.gif