Subject: Metering pump and oil cooking.
From: Paul
Date: 2/25/1999, 1:43 PM
To: z

Jeff Spitzer wrote:

Paul Yaw wrote:


Most synthetic engine oil, when it does burn, leaves even more shit
behind than regular motor oil.  Try burning several different types of
oil, and you can clearly see that the amount of crud left behind varies
a great deal from one type of oil to another.  As for putting the oil in
the right place, I cannot believe that a low pressure injector (it just
dribbles) in the center of the rotor housing can distribute the oil very
well.  Thorough mixing with the fuel before entering the engine will
lubricate more evenly, and the oil has a better chance of making it into
the apex seal groove which is equally important.  The most important
point is simply that two stroke oil is meant to work in the combustion
chamber which is exactly where we are putting it.  Two stroke oil is
VERY different from motor oil.  Mazda uses engine oil because they
simply could not sell cars that have a fuel tank, and an oil tank.
Hell, it seems that most airplane guys aren't even very hip on the idea
of having to screw with an extra fluid.  I can tell you from experience
that high quality two stroke oil makes all the difference in the world.
When you disassemble an engine that has been fed ts oil all its life,
the engine is much cleaner internally, and the apex seals, rotor
housings, and apex seal groove have a finely polished look rather than
the typical grooved uneven wear patterns that are evident in street
engines.

Paul Yaw

Maybe this is why Mazda recommends against using synthetics in the RX7.  I
know that I use synthetic motor oil when I *don't* want the oil to break
down at high temps.  I never really thought about what would happen if it
does.  I can easily see how it might leave more crud than mineral oil if
burnt.  As for the previous discussion about directly lubing the tip seals
I think the chamber oil is also important for the side seals so the
previously posted "feed the trochoid" argument is kinda hollow.  Also on
two stroke engines, where all the oiling is done through mixture, its
amazing how when you tear it apart you find oil in the bearings, etc.
Common sense would say that the oil would be washed away by the presence of
the fuel, etc.  It just doesn't work that way.  Oil in the mix deposits on
the walls, seals, etc.  It just works.

Jeff Spitzer


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org