Paul Yaw wrote:
Paul wrote:
Todd Carrico wrote:
All this talk of the oil injection reminded me of an experiment I ran
a few years back. I was playing with water injection, and ended up
drilling a HOLLEY carburetor ventury and inserting a tube that feed
water from a tank (2 litter coke bottle). I had machined a block of
aluminum to accept a standard HOLLEY jet. To adjust the water, change
jets. This metered water into the ventury of the carb and I guess
mixed well with the A/F mixture. I got bored with it and sold the
car. It would be the best of both worlds, separate oil tank, and no
pump or pressure lines. Something to ponder. You could add the oil
anywhere along the intake manifold as long as you weren't turbo'd.
Todd Carrico
That's a pretty good idea. I wonder if it would work with
a reasonable size ventury given the viscosity of two stroke
oil.?
This would just be a matter of venturi signal, jet area, and the height
relationship between the tank and the venturi. The only problem I see
is that the oil flow would drop off as the oil level in the tank
changed. You could even use an air bleed to help emulsify the oil.
Just like a carburetor. It would proably work even better if you mixed
the gas and oil 50/50 to reduce viscosity. What a GREAT idea. I am
tired of carrying two stroke oil behind the seat of my truck. Thank you
VERY much. Why didn't I think of this before?
Paul Yaw
Draw backs to a venturi are iceing and a power reduction.
What might also work is a constant dribble or drip system turned on an
off with
a solonoid valve connected to the ignition key.
It would still dribble with the tank near empty if the tank was pancake
shaped. There should be a mild vacume in the intake chamber where the
lube oil injectors are.
Next time you are running a rotary on the dyno you could hook up
a manometer to the oil injector port and check.
Another possibility is using pitot tube pressure
to put a mild pressure in the oil feed tank. The pitot tube can be
mounted
behind the prop so it senses slip stream dynamic pressure. Slip stream
pressure would be higher than airspeed in climb and takeoff.
Nine pounds per square foot at 60 MPH or .065 PSI.
At 100 MPH it is .18 PSI. at 200 MPH it is .7 PSI.
The formiula is: MPH^2 times .0026.
PL
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org