Subject: Are air cooled aircraft engines modern?
From: Paul
Date: 2/27/1999, 3:57 PM
To: z

Archie Frangoudis wrote:

Thanks for the commentary Paul, and you are right, this debate could go
on
forever, but: 

Without revealing everything....... In relating to the model
A, I was referring to ring design and material, plus the break-in. When
I
reworked the O-200, I incorporated the latest ring designs, and no
cross-hatching. Break - In was ground running only. By the time the
plane
was ready for takeoff, the engine was essentially +ACI-broken in+ACI-.

Ring gaps were not determined by a +ACI-book+ACI- but by dyno work.
Piston
clearance was actually less than mfg. specs. As far as dependability,
and
trustworthiness, if these are so good, why are we seeking alternatives?
(I
know, I know, many reasons). 

I am set up to do most anything relating to piston engines, but am also
keeping an open mind regarding the rotary, and by reading all the
commentary
on this site, am leaning progressively in that direction for my next
aircraft. Unquestionably, I have learned more from Paul Yaw and Tracy
Crook,
Plus this site, than any other source in the past. 

Thanks again, 

Archie


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org