Bill Freeman wrote:
Paul,
Hey - I'm a structrues guy - not gonna do anything dumb in
the structure of the Long EZ, like leave out the floor of the
fuselage. :-o
So, I built the normal fuselage bottom
structure which has essentially the correct ramp angle for the
floor of the duct. I built a moveable floor from 1/4" foam with about
4 plies on both sides and tapered the core at the front to zero and
added some more plies in the front. The floor starts about 70% of
the way from the rear to the front of the duct, has a fwd hinge and
dual wide-spaced pushrods in the rear plus a linkage
in the 'hellhole' under the pax backrest. Have removed the
pushrods and blocked the ramp partially closed, two positions
summer/winter. On first flight
the engine got hot, couldn't figure out why - everything was OK.
Eventually found out that the pressure differential was closing
the duct completely in flight against a strong spring which was
**supposed** to open it wide if the linkage were to fail. OOPS!
Too many sq inches, and cowling plenum pressure on the
backside.
Would work fine with a jackscrew, I'm too cheap and lazy to
put it in.
Bill
Since we are talking about pusher cooling systems.. here is a picture
of the fastest O-200 powered Variez in the world. Klaus Savier's.
Notice the huge size of the opening. Apparently it is most
important to avoid separation on the outside of the cowling.
This is used of course with a large NACA duct on the bottom.
Klaus usually runs a weird spinner. For some reason he had
it off when this picture was taken a couple of days ago.
klaoutlt.jpg
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org