Wschertz@aol.com wrote:
I have some reservations about the addition of two-cycle oil to the gas, that
center around the proper mixing of the oil and gas. When I mix it up for my
snow-blower, or chain saw, I am careful to add the oil to the can, add a
LITTLE bit of gas, and then thoroughly mix it by sloshing it around for a
while before adding the rest of the gas. This is the instructions that came
with the equipment. They cautioned that just pouring the oil into the gas
might create unequal mixtures in the can. I have observed the oil going into
solution, and it sort of sinks to the bottom and slowly dissolves, but can
create an oil-rich area (which means there is a corresponding oil-lean area)
near the bottom of the can until I do the vigorous mixing. It DOES NOT
dissolve instantly.
Now I KNOW that airplanes move around and jostle and jiggle, but I envision
the following being easy to have happen:
You have the gas added at the airport, then you pour in the required amount of
oil. It settles down through the gas in the tank, hits the bottom of the
tank, and proceeds to flow down towards the root of the tank (past baffles in
my plane), and is thereby prevented from being perfectly (or even adequately )
mixed with the gas near the filler cap. You get oil-rich gas for a while,
then oil-lean gas. Even the recirculation from Tracy's fuel injection would
only mix the innermost baffle compartment.
As a proposed solution, how about a metering device that can be slipped over
the nozzle of the fuel truck, that has attached a reservoir of the two-cycle
oil, and is constructed with a venture, so that a metered amount of oil will
go into the gas as it is being pumped into the tank through the nozzle. This
would provide vigorous mixing of the oil with all the gas. The type of device
I am talking about is the principle of the Ortho Hose End Sprayers for
herbicide or insectide. You put the concentrated solution in the jar, and let
the water going through the nozzle pull the solution into the water and out
the nozzle.
Bill Schertz