I think this is what Allan had in mind. I shortened the
PSRU to 11 inches. I also checked the length of the cowl
out at the Flabob EAA Chapter 1 flyin yesterday and found
that I was 4 inches too short on the length. That gave us
a little more room for the rad behind the engine.
The muffler could probably be changed to the tuned type
and moved to a place under the engine. This would make
it easier to seal the radiator from muffler heat.
This is basicly an internal diffusion type of cooling system
where the upper part of the cowl plenum is used as the
diffuser. As such it should require only small holes
in the front of the cowl for intake air.
rv6cool4.gif
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org