Date: Sun, 31 Jan 1999 23:33:51 -0800
From: Paul <rotaryeng@earthlink.net>
To: z <rotaryeng@earthlink.net>
Subject: Building your own E-shaft ignition trigger.
Tracy,
I added the signal conditioning.
You need it because the photo transistos collector
sits at near 12 volts when the transistor is dark.
When it receives the high power pulse of infrared through
the hole it goes down to about 5 volts so that is
the reason you need the 1 mfd ceramic capacitor.
Don't worry it will start to work as low as one
RPM.
The five volt three wire
regulator for the LED can be used to supply voltage
to the hex schmidt trigger. In fact it can be physically
located on the same aux pc board. The 600 OHM pull up
resistors to 12 volts may need to be adjusted for the
photo detectors as the brand is probably different
than the ones I used for so many years (I used a TIL
81 as I recall).
Also if the circuit is picking up too much noise from
the 12 volt battery you might want to put an 8 volt regulator in
there to supply the photo transistor pull up resistors.
I doubt however that this will be necessary due to the
low impedance of the circuit. You want to keep that supply
as high as possible so those photo detector transistor
switch as fast as possible.
The schmidt trigger is wired as a poor man's comparator.
You can mess with the ratio of the top and bottom
10K resistors to change the trigger level. I forgot
why the 1K resistor is in there. Probably for a good
reason :-) The 1N914 diodes shunt the excess voltage
so to speak.
Test the circuit with a disk in a high speed drill
motor or better yet... a drill press so you have some idea
of the RPM.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org
______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com