Anderson Ed wrote:
Alan,
If I recall correctly, Hatch undertook some significant weight
reduction measures with the rotary engine. Also, his PSRU would appear
to be lighter than the Ross PSRU (shorter). From the photos I have seen
of the RV-3 I would say his radiator and oil cooling set up saves a few
pounds over mine. If you have the weight of his block how does it
compare to the 194 lbs (I believe) of the stock 13B? I know his intake
manifold and exhaust system is lighter than mine. My exhaust system
alone with the two mufflers weighs 28 lbs. My intake with throttle body
and homemade(will redo this item in the future) intake manifold weighs
27 lbs, again I am sure Hatche's was lighter. My extra 25 AH battery
adds another 22 1/2 lbs.
So, I don't know if this information along with my W&B figures helps
shed any light on the 1170lb weight or not. I must admit it was heavier
than I had anticipated, but I can't point out one single thing that
added 100 lbs more than a standard RV-6A. Just the accumulation of a lb
here and a lb there.
Ed Anderson
Wow Ed, that is a heavy exhaust system. An 0.040 thick Inconel with the
stock flange would be eight pounds. With 0.060 stainless it would
be 10 pounds. With the Hatch type four bolt flange you could knock
another couple of pounds off that.
PL
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org