Subject: CG in the rotary powered kit plane
From: Paul
Date: 3/4/1999, 8:41 AM
To: z

Anderson Ed wrote:

The exhaust system is heavy, I actually use 304 stainless steel pipe
used in constructing railings and it is 0.0624 wall thickness.  I guess
the horria stories I have heard about the blow tourch effect of an leak
in a rotary exhaust header led to to "over-kill".  But the 18 lbs of
stainless mufflers are the major part of the weight. I have toyed with
taking them off an still might, but they do keep the roar down.   I like
the idea of using Inconel and eliminating some of the metal out of the
exhaust flange.  Just did not feel up to drilling a hole in the block
for additional mounting studs.

I also have a lot of unneeded weight in the intake system.  My slab
manifold, heavy cast alumn mazda - weber adapter and the weber throttle
body are all heavier than they should be.  Besides that I am apparently
losing power due to its poor flow characteristics.  I believe that is
what I am seeing as the last two inches of throttle travel which fully
opens up the butterfly valve do not cause any effect in manifold
pressure or rpm.  So I think the intake system is limiting the flow -
just my best guess at this point.

By the way, appreciated your words of encouragement.

Ed Anderson

Well one good thing about those mufflers they are just about on 
the CG.

PL

The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org