Subject: Kit aircraft weight and engines that talk to you.
From: Paul
Date: 3/5/1999, 12:37 PM
To: z

Anderson Ed wrote:

Thanks Alan,

        No, did not expect you to remember me out of the thousands you have
met, but I was appreciative of your taking the time at that point to
discuss your RV experiences.  By the way, did not mean to give you the
impression of sensitivty about my aircraft weight, not so. I do point
out to some detractors of auto conversions that the weight of the rotary
vs Lycoming is a non-issue and that a number of RVs with lycomings weigh
more.  Did not interpret you comments as crticism, but simply a desire
for information about what led to the 1170 lbs.

I am always willing to share the good, the bad, and the ugly of my
attempts with others in hopes that: 1. They won't do the same dumb thing
I may have done (Can't advance the state of the art by repeating someone
elses mistakes)
2. Someone who has done it a better, quicker, cheaper way will share
that info with me.

  Clearly I wished it weighed less, but on the other hand it still
performs 150% better than anything I had flown previously - what a
pleasure to fly.

You are right about taking off after the rough engine start up.  I
should have checked the plugs/engine before flying.  It was a cold
morning and I chalked up the initial rough runing to COLD start injector
timing nor being rich enough as it did smooth out as the engine warmed
up.  Clearly not a bright assumption to make, the engine was trying to
tell me something. I guess in a way it still shows the advantages of a
rotary in the sense that it continued to function (abeit less
efficiently)even with the plugs in such sad shape.

If the snow/sleet/rain/wind forecast for this week end permits I will
try out the new "snorkel" inlet for the oil cooler per Paul L
suggestion. I think that Paul Lamar's comment about the position I had
the NACA opening not being optimal is correct.  It probably looked
pretty much like a flat plate to the local airflow, so will see what
this inlet does.  Will report results next week.

I agree with your comment that leaning at altitude was probably a major
factor in my plug erosion.  I flew the first 15 hours with the high rpm
mixture clearly very rich without any plug erosion, I then adjusted the
injectors back 15-20%.  My mixture control would then lean it
sufficiently that the engine sounds would take on on a distinctive sort
of flatter note - may have been onset of detonation from overadvanced
igntion timing and leaning.
In anycase, it sure ate the spark plugs.

Ed


 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org