Subject: Amphib PSRU, Hoffman, MT, and crank oil supply
From: Paul
Date: 3/6/1999, 10:45 AM
To: z

MAR34807@aol.com wrote:

In a message dated 3/5/99 5:40:50 PM CST, rotaryeng@earthlink.net writes:

<< BTW Peter you will need a 3:1 PSRU and a variable pitch prop
 for optimum results. What is the max diameter of prop that
 the Sea Wind can use. A large diameter multi-blade low pitch
 prop would work best. Hoffman in Germany makes such a prop
 but they are expensive. The max diameter of the prop is going
 to determine how much power you can get out of a 13B.
 Able comes off the line at 10,000 RPM and shifts at 8500 RPM
 so you need to calculate the mach number of the blade tips.
 It should be less than about .8 but .9 might be acceptable
 in areas where noise is not so important.
  >>
I have looked into this for my amphib kit (with the 20B I plan on using) but
run into severe limitations.

1. Low idle is reportedly poor with the Ross PRSU, and idle must be elevated
(due to gear tolerances?) This is a no no on the water; dead low rpm is
needed. A reversible prop makes water maneuvering easier, too, and would be
ideal (or a very small light weight jet ski jet pump, any help avail here?
rotor models available?!)

2. All props suitable (Hoffman's reverse pitch) require a center hub oil
supply. None of the PSRUs this capability. I know of no one who is even
working on a conventional oil supply scheme for any PSRU-why not?

3. Best prop so far is the Hoffman 4 blade, now being tested in a Seawind.

4. Does Hoffman make electric controllable props? I think not.

MT-Propellors  DOES make electric controllable pitch props.
See the ad below.
 
My prop design can be set for reverse pitch as a minimum and controlled
through feather up to high pitch. It all depends on where you
set the initial blade angle. The total pitch change is about 
40 degrees. See the ACRE web site below. With a minor mod
to the pitch change mechanism I could get plus or minus
40 degrees pitch change.

Also if you are building your own PSRU based on the Ford C6
and you decided to use plain bearings with the oil supplied
from the engine it would not be that hard to mount a stock
prop governer. You will need a gear on the output shaft
to drive the governer. 

Tracy is working on a plain bearing/engine oil supply PSRU
based on the Ford C6 planetary as we speak. I don't think it has
provisions for a prop governer so far however.
(Sorry Tracy... creeping features again.)

PL 


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org

mt-prop.jpg