Subject: What I know so far about rad ducting.
From: Paul
Date: 3/6/1999, 2:06 PM
To: z

What I know so far about radiator ducting.
Please correct me about any of this if you think I am wrong.

The top speed of an airplane is directly proportional to drag
while it is also directly proportional to the cube root of HP.
That means it is far easier to reduce the drag then cube the HP.
Cooling drag is the most important part of the drag the
homebuilder has the ability to reduce as most kit planes are cast
in concrete as far as reducing external drag is concerned.

Any external scoop added to the airplane will increase drag by
increasing the frontal area and the surface area of the
airplane. Long internal ducts with high speed airflow will also
increase the surface area and therefore the drag.
Radiators like high pressure, low speed airflow to maximize heat
transfer. More molecules of air hang around longer to be heated
up. Lower velocity air flowing through the core of a radiator
creates less drag.

Fortunately nature has provided a solution. Pressure one times
velocity one equals pressure two times velocity two in a duct
that gradually changes its cross sectional area.

P1 X V1 = P2 X V2

I am not sure who discovered this.

This means if we have an open, straight thru duct with an opening
facing forward it will receive air at a velocity equal to the
forward speed of the airplane and at a pressure equal to
atmospheric pressure. As the duct changes area the velocity and
pressure of the air inside will change. If the outlet of the
duct is the same area as the inlet the air exiting the duct will
be almost the same speed and pressure as the air entering the
duct. The difference is due to skin friction inside the duct. To
minimize the skin friction drag the air should be slowed as
rapidly as possible without causing separation or turbulent
flow and be speeded up as rapidly as possible before exiting.
This mechanism of slowing the air inside a duct is called
"internal diffusion".

This is all well and good for a duct with no obstructions inside
such as a radiator. This is when the problem gets complicated.

If the duct is closed off completely the air going into the duct
will be zero and the pressure at the entrance of the duct will
be what is known as dynamic pressure or 0.0026 X MPH^2 in pounds
per square foot. If you measure the pressure several inches in
front of such a duct you will find the pressure is somewhere
between dynamic pressure and atmospheric pressure. This type of
duct is called "external diffusion" and the internal drag is
zero. However the duct still may cause drag as air must spill
over the outside and perhaps separate from the surrounding
surface and cause turbulent flow.

This is not likely to happen if the entrance to the duct is
located on a blunt vertical surface such as the front of the
cowl. IMHO this is the only place such a duct entrance should be
considered.

Reality lies somewhere between the two types of ducts.
Until we have radiator data on pressure drop verses heat
transfer we are floundering around in the dark.

PL

The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org