Neil A. Kruiswyk wrote:
Paul L Wrote..
Any external scoop added to the airplane will increase drag by
increasing the frontal area and the surface area of the
airplane...
Paul,
You forgot to note that by adding an external scoop you don't need the
original nacels thereby reducing the cowl drag. Depending on how bad the
originals nacels were and how good the belly scoop is, you can decrease
drag. Such is the case for Lancair 235. Not so much for the 320 versions.
RV4's and 3's would probably be a wash since you can get rid of the cheeks.
An RV6 is another kettle of fish since it has a mamouth cowl.
Exiting air also causes drag. On an original cowl, the exit area is
usually quite bad which is also not needed (or reduced considerably) with a
scoop.
And lets not forget all the drag inside the cowling. Air has to go all
around and through the block, mounts, hoses, wires or very spiffy exit ducts
would have to be constructed which themselves would have to make some
interesting bends. Here again a scoop allows air to go pretty much straight
in and straight out. So.... much of it depends on the aircraft and the
builder.
Hopefully that air is not moving very fast so the losses should be
minimal.
Lastly... air entering a duct should be at least 3 times the cord of
the prop blade behind the blades otherwise turbulence will reduce airflow
into the nacelles. I don't ever recall seeing a prop that far forward of
the nacelles. This is not an issue with a scoop.
Maybe we should all build Long-eze's...
IMHO
Neil
Good points Neil thanks. I will add this to the text which will
eventually
wind up on the web site.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org