A similar relationship to P1 X V1 = P2 X V2 is velocity one
times area one equals velocity two times area two or:
V1 X A1 = V2 X A2
(V1 X A1) / A2 = V2
Let's say V1 is two hundred MPH and A1 is a hole six inches by
six inches or 36 square inches. If we dump that much air into a
cowling chamber 48" by 18" or 864 square inches V2 should be then
only 8 MPH. This is why the drag of the engine and its parts
is not that important.
The drag of say an alternator in the slip stream at 200 MPH
would be .0026 X 200^2 times the drag factor of the alternator
(lets say that is 0.65 ) times the frontal area of the alternator
(about 0.14 square foot) or about 9.5 pounds.
200^2 X 0.0026 = 104 pounds per square foot is the dynamic
pressure at 200 MPH.
104 X 0.65 X 0.14 = 9.5 pounds of drag.
9.5 pounds going 200 MPH or 280 FPS will suck up about 4.8 HP
since one HP = 550 pounds going one Foot Per Second.
The same alternator inside the cowl at an air velocity of only
8 MPH would not be noticed.
This is also why we use diverging radiator ducts in the first
place.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org