Subject: Two Stroke Oil as general system oil.
From: Paul
Date: 3/7/1999, 2:44 AM
To: z

Mike Richardson wrote:

My early seventies 2-stroke Moto-Cross and Flat Track motocycle
experiences, as a sponsor and racer, indicated high wear
characteristics. Clean yes.....and extremely dry lower ends. I believe
we also found Klotz to be water soluable. I've seen rings rusted to
cylinder walls after a bike had been parked in a cold damp garage.
Later changed to Bel-Ray MC-1+ @ 60:1....Excellent results. Lower ends
stayed coated, but not excessive.

Wanted to use it in my 503 Rotax'ed Quick and found Valvoline
(80cts./pt. in bulk ala qts.) 2-cycle oil @ 50-55:1 was being used by
local trainers and friends with unbelievable results, 500hrs.+ without
so much as a ring job. Inspections indicate: no stuck rings, no carbon
build-up, no noticable cylinder wear.......no plug problems.
Didn't try and re-invent the wheel, used it , love it!
Rotax recommends top end tear-down @250hrs.

Everyone.........well...... a lot of people have a 2-stroke oil they
swear by and the bottom line to a happy 2-stroke amounts to proper
jetting vs.mixing ratio for their application and thoroughly mixed
fuel/oil. The other folks swear "at" their 2-stroke.

Please note that none of this may apply to rotaries, turbos, crankcase
oil, and/or aircraft use in general, it's just "food for thought" from
my experience.


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org