Neil A. Kruiswyk wrote:
Paul,
I'll agree that the bouncing air inside the cowl, after leaving the
radiator cores may not be such a big deal, drag wise... but... Your 8
mph cowling air has to get back up to 200mph somehow when exiting the cowl.
Isn't this going to take some energy to accomplish?
I'm not suggesting for a moment that rads in the cowling are a bad
thing. It's a very good thing if you have the room and the weight and
balance works out.
Neil
The air is slowed in front of and behind the radiator core.
By the way the cowl then becomes a pressure chamber and any
leaks will cause trouble with the external boundry layer.
Racers.... tape the joints to seal the cowl.
Due to the issue of modifying an aluminum airplane like the RV
for a P51 style duct the rads in cowl are a necessary evil.
For a composite airplane like the Lancair the P51 style
rad duct can be bonded to the structure making it stronger
if done right. I would also like to investigate the
replacement of the P51 style intake scoop with a
large NACA duct.
I would not hold my breath waiting for a shorter PSRU.
It looks like we need to make the best of the situation.
So far Tracy, Ed's and Jim's configurations looks like the
way to go. Of these I like Jim's arrangement the best. The
maximum amount of internal diffusion is taking place. Probably
only minor improvements can be made in the area just behind the
cowl openings.
As far as the outlet duct is concerned; yes there will be some energy
lost speeding up the air and gettting it to go in the right direction.
An externally streamlined, dropped section of the cowl with or with
out a cowl flap and a firewall streamliner looks like the best
solution at this time. The firewall streamliner is very important
with an RV6A as all that gagle of tubes down there are in a
relatively high internal air velocity area.
If necessary two 1.75 inch diameter down pipes from the muffler
could be used to limit the height of the dropped cowl section
to two inches or so.
Paul Lmar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org