Subject: Ed's oil cooler Snorkel Nozzle
From: Paul
Date: 3/8/1999, 10:35 AM
To: z

Anderson Ed wrote:

Hi Paul,

I had some success this week end.  As you suggested I ditched the NACA
duct an replaced it with a "snorkel" nozzle with a 3" (nominal) dia
opening. (similar to the carburetor snout on the lower cowl of the RV).

I built one up of fiberglass and simply pop riveted it over the NACA
opening (being somewhat skeptical, I did not want to ruin my NACA
opening since it did keep the oil temp within bounds except at WOT).

It was a cold, very windy day so debated launching, but decided to do
so, so as not to spend the rest of the week wondering if the mod did
anything for my oil temp.     Much to my surprise it dropped the oil
temp 15-20F.  I could fly at WOT (6000 rpm) at 6000 MSL and oil temp
varied between 180F and 190F.  I could not believe it. Previously at
6000 rpm my oil temp would climb to 210-220F.  So I will undo the pop
rivets and shape the cowl opening to match the Snorkel nozzle which
should help even more and fiberglass the new nozzle to the cowl.  Now,
(as usual on the weekends), it was on the cold side 39F at the surface.
However, even when it was 15F the NACA duct simply would not keep the
temp down at WOT. We will see how it does on warmer days, but this has
been the biggest single improvement to my oil temp thus far. Actually,
doesn't look bad, sort of like a RV with 37 MM Gatling gun opening (RV
Warthog!{:>})Great suggestion, Thanks!

Ed Anderson

Hey I did not just fall of the aerodynamic turnup truck :-)

NACA ducts work best on a zero degree angle up to about 30 to 45 degress
after that you are better off with a vertical opening.

Thanks for the complement Ed.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org