Subject: What I know so far about rad ducting.
From: Paul
Date: 3/8/1999, 10:45 AM
To: z

Anderson Ed wrote:

Hi Paul,
        In an earlier post, I mentioned following your suggestion and place a
"Snorkel" air intake over my NACA duct opening and got a 15-20 drop in
oil temp.  I noted the JPG you posted about turbulent flow inside front
sides of most common duct and revised my Snorkel to provide straighter
sides (slight curve).  My Snorkel is on the front right under the right
side radiator opening about 4".  I suspect the NACA duct was too flat on
to the local airflow and being shallow was dumping a lot of air around
it. So don't now if my kluged up arrangement with a Snorkel on top of a
NACA opening fits any category {:>}. But, in any case, the results was a
15-20F drop in oil temps at WOT (6000 rpm), now running 180-190F vice
210-220 See attached Snorkel drawing (MS Word)for sketch of
installation.

Ed Anderson


Ed, do you have a paint program? Most paint programs will output
either GIF or JPG. I can't handle MS Word graphics.

Paul Lamar
 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org