MAR34807@aol.com wrote:
In a message dated 99-03-06 12:44:22 EST, you write:
<< Also if you are building your own PSRU based on the Ford C6
and you decided to use plain bearings with the oil supplied
from the engine it would not be that hard to mount a stock
prop governer. You will need a gear on the output shaft
to drive the governer.
Tracy is working on a plain bearing/engine oil supply PSRU
based on the Ford C6 planetary as we speak. I don't think it has
provisions for a prop governer so far however.
(Sorry Tracy... creeping features again.)
You could possibly run a governor off a belt on the rear of the engine, yes?
What would be the disadvantages of a belt(s) run governor? (besides a broken
belt?) I have heard that this has been done before.
Plumbing the oil in and out and then to the prop seems to
be the main problem as the V pitch prop is normally fed through
the hollow crankshaft.
Paul Lamar
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org