Subject: Car rads for potential use in AC.
From: Paul
Date: 3/9/1999, 10:48 PM
To: z

Bill Freeman wrote:

             snip

Did you find any aluminum ones that don't have plastic end tanks?  That too
seems to be all the rage.  Anyone dare run one of these on an airplane?

Jeff Spitzer

The crimped on plastic end tank seems to be standard now-a-days.
I think there may be a possibility of welding on an aluminum
end tank. If not perhaps fabing alloy end tanks and bending up
the tabs and installing the alloy end tanks in place of
the plastic.

Paul Lamar

My guess is that the plastic end tank will be fine if you are
careful to replicate the vibration and thermal conditions in the
typical car.  These things run 200K+ miles without a significant
failure rate, but are soft-mounted and temps are kept reasonable.
If the plastic were to "see" the exhaust system, the radiative
heating may be fatal - in more ways than one.  If some care is
taken, it would not seem too risky to use an Alum/plasitic rad.

My 89 Accord has  plastic tanks, but the fins are black - may
be aluminum or may not.  I happen to respect Honda a lot
esp in the engine compartment.

Bill


The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org