Tracy Crook wrote:
It would not hurt to look at them through the exahust port Ed but
if they are not broken it is probably a long term wear issue.
Stick a small inspection mirror in there and look at the rotor
housing surface while you are at it.
Paul
Yes, this is a worthwhile check and if your hot cranking speed compression
is OK then the worst that has happened is probably just accelerated wear.
Look for a chamfered edge on the apex seal tip as opposed to the normal
rounded edge. If it's still smooth & round you don't need to loose any
sleepover it.
Tracy Crook rws@altavista.net
The Aircraft Rotary Engine Newsletter. Powered by Linux.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org