Subject: Hi Temp apex springs. Inconel Springs - correction
From: Paul
Date: 3/10/1999, 11:51 PM
To: z

Bill Freeman wrote:

Paul,
I posted too soon!

I started researching Inconel springs and found Inconel
alloy 600 and alloy X750 listed as spring materials.  So,
there are at least two Inconel alloys that are useful at
a high temp range.    Inconel 600 is rated at max temp
of 700F and Inconel X750 is OK as a spring up until
1100F ---- wow!    I imagine that annealed Inconel is
still worthless, but the annealing temperature of the
alloy X750 is very high.

Beryllium copper springs are only good to 400F.
17-7PH stainless is OK to 700F.
301 or 302 stainless is OK to 600 F.

These are the only really high temp materials in the
list - Shigley's Std Hbk of Mach Design, 1986 edition.

Beware that the SS301/302 ONLY work harden, and
would be pretty tricky to make without the proper
development work to ensure enough strain during
rolling or whatever to get the proper hardness.  May
be able to buy flat spring stock already hard, although
working with hard stock is difficult.  17-7 PH is
heat treatable, so may be easier to get the right material
condition after forming.
 Inconel X750 is  a heat treating alloy, apparently by
high temperature aging at 1200 degrees for 4 hrs.
Inconel X750 relative cost factor is from 31X to 44X
compared to ordinary cold drawn carbon steel wire
springs.   Yikes!

Bill

Yes but we only need just a tiny bit.

Paul

The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org