Subject: Hi Temp apex springs.
From: Paul
Date: 3/10/1999, 11:44 PM
To: z

Bill Freeman wrote:

Paul,
I have some Inconel safety wire which is annealed
(as would be any spring the got hot enough to
need to be made out of Inconel) and it is dead
soft, would make a pretty worthless spring.
Unless there is a very different alloy of
Inconel (I do think there are a few variations on
the alloy) it will not make a good spring,
either flat or wound.   The yield seems to
be very low, but ultimate fairly high.  So expect
lots of permanent deformation at fairly
low stresses.  Probably work hardens,
but anneals back at first hot cycle.

I need to look at the high temp properties
for beryillium-copper, it makes great springs
and seems like it is good to fairly high temps,
but that is just memory and may be very
wrong.

Bill


Yield for Inconel 718 is 152K psi at room temp and 126K psi at 1200 F
Nothing in Mark's can touch it at 1200 F and above.
At room temp spring steels can go over 200K psi

Paul

 
The Aircraft Rotary Engine Newsletter.              Powered by Linux.

http://home.earthlink.net/~rotaryeng/            http://www.linux.org